Mill Supply has a complete selection of floor pans for your 1955, 1956 or 1957 Chevrolet Bel Air Sport, Nomad, Two-Ten, or Convertible. Floor pans are available in sections for single area replacement or as one large unit for the total restoration job. Starting at the front of your Chevrolet, Mill Supply carries the toe board section (this section is the area that slants up and sits behind the gas pedal and brake/clutch); the front floor section for the driver or passengers feet area (this measure approximately 19” x 24”); the transmission hump which is separate from the front floor pan sections; under the front seat (measuring approximately 19” x 30”); rear seat feet area for the Hardtop, Sedan or Convertible; and the rear seat riser area for the Hardtop or Convertible. You can also purchase the center area that includes the front floor, under the front seat and the rear seat feet area, as one unit. Complete floor pan assemblies for the Hardtop, Sedan or Convertible are available special order and include the floor braces. Complete assemblies are special order and must be shipped by freight.